For amateur radio operators, linear and switching power supplies are the most common power supplies
topologies used today. Linear power supplies have been in the market for many
years, while switching power supplies are becoming more widely used because of
its advantages — cheap, high efficiency, small size, and low heat generation.

Linear power supplies are typically used in R&D environments and in production
test systems. They provide high performance, low periodic and random deviation
(PARD), that is, less voltage ripple and noise, excellent line and load regulation, and
superior transient recovery time.

When compared with switching power supplies,
linear power supplies are relatively inefficient. Due to their design, they tend to be
cumbersome, bigger. Typically, linear power supplies provide the most effective solution in
low-power applications.

When choosing an instrumentation-grade power supply for bench-station testing,
you must consider efficiency, size, transient time, and price, with the key factor
being noise performance of the instrument. Generally, linear power supplies have
less noise compared to switching power supplies. 

However over the years, the
design of switching power supplies has improved and the noise performance for
switching supplies is as good as it is for linear power supplies. However, low-noise
switching power supplies are more costly
. Normally, low-noise switching power
supplies are mainly for high-power applications, while low-noise linear power
supplies are suitable for low-power applications.
In this article, you will learn and understand why do we need low-noise linear
power supplies and how linear power supplies compare to low-end switching power
supplies for the same price range.

Do we need low-noise power supplies? 

Low-noise power supplies are essential in certain low-power applications, and
the key advantage of linear power supplies are low voltage ripple and noise.
If you use low-end switching power supplies with high output noise, or if you
want to remove unwanted noise, you must add electronic filters (capacitors),
electromagnetic interference filters, or radio frequency (RF) shielding to low-end
switching power supplies in low-noise applications. Unfortunately, the filters
and shielding add complexity and cost to the applications.
Obtaining a clean output signal when you are transmitting and receiving RF
signals can be challenging. Low-end switching power supplies may contain
many high frequency spectral components in their DC output, while linear
power supplies normally do not have high frequency noise in their outputs and
therefore will not cause interference in RF applications.

Powering active antennas, down-converters, or preamplifier requires very
low-noise power supplies. Any noise superimposed on the DC power can enter
the antenna or the antenna lead and interfere with the useful signal. Also,
electromagnetic interference generated by the power supply can enter the
receiver input and reduce the signal-to-noise ratio of the received signal.
Figure 2 and Figure 3 show how a circuit powered by a power supply can affect
an RF signal.

Operational amplifiers (op-amps) used in analog audio circuits and high-density
ICs in digital systems are highly sensitive to noise from the power supply. When
an op-amp has its input referenced to the supply, any high frequency noise that
exists in the low-end switching power supply will be coupled with the output.
For example, when you design a simple op-amp based headphone amplifier,
noise and ripple from the power supply may affect the output measurement of
the on-amp and its performance. Using bypass or decoupling elements will clean
up the output, but it will increase the design complexity and product cost.

C O N C L U S I O N 

Both linear and switching power supplies have advantages and disadvantages. Low-end switching power supplies
are commonly used in many areas because they are more efficient and cost less, but they are not optimal for noise
reduction. If you are looking for performance and noise-free power, a linear power supply or a high-end switching
power supply is your best choice.

By 9M2PJU

Amateur radio operator from Malaysia

Leave a Reply

Your email address will not be published. Required fields are marked *